R1WURKS DD4 High Torque/Speed Low-Profile Servo

This high-voltage servo is essential for any racer aiming to enhance their on-track performance. It delivers massive torque and speed, providing the ultimate in steering control. Your steering inputs will not only feel more direct but also remain consistent under load. Whether you're maintaining a tight line through a sweeper or making rapid direction changes in a high-speed chicane, you'll feel more confident than ever with this servo doing the work.
Machined aluminum billet case for strength and rapid heat dissipation
MonoChromatic wire coloration [Negative=Black, Positive=Black, Signal=Grey]
Full stainless steel gear train
Hi voltage capable
UlTRA high torque
High Speed
80mm Wire length
25T Spline
brushless Motor
Weight: 2.35oz
333Hz Refresh Rate
FET Motor Drive
Dual Ball Bearing
Pulse Width Modulation Control
Magnetic Sensor
Full Aluminum Case
Stainless Steel Gear Train
Voltage: 4.8V to 8.4V
Torque:
20 kg-cm (278 oz-in) @ 4.8V
25 kg-cm (347 oz-in) @ 6.0V
30 kg-cm (417 oz-in) @ 7.4V
33 kg-cm (458 oz-in) @ 8.4V
Speed:
0.110sec/ 60 @ 4.8V
0.090sec/60 @ 6.0V
0.080sec/60 @ 7.4V
0.068sec/60 @ 8.4V
This item fits the following: Fits most applications. Please refer to the dimensions to ensure compatibility with your vehicle.
There are no standard dimensions for what constitutes a low-profile servo. Therefore, it is essential to carefully review the specific dimensions of the servo below. Compare these measurements with the servo mounting area of your vehicle to ensure proper fit and compatibility: