Front & Rear Skid Plates for the Losi Tenacity

If you're looking for some bulletproof protection for your Losi Tenacity (SCT, T & DB), look no further than RPM! Front & rear skid plates are designed to fit both the molded chassis version of the Tenacity as well as the aluminum chassis option.
Molded Chassis versions of the Tenacity
A key breakage area of the molded Tenacity chassis reported to RPM engineers is the area located just behind the front bulkhead mounting screws. By tying together the four bulkhead mounting screws with the two screws holding the steering mounting posts in place, beefed up the strength and durability of the entire front end of the chassis, helping to reduce that pesky breakage problem while adding some much needed abrasion resistance to the chassis.
Aluminum Chassis versions of the Tenacity
It only makes sense to protect that chassis for as long as possible. What better way is there than a product specifically designed to reduce skid and abrasion resistance? Skid plates will not only increase the longevity of your valuable aluminum chassis, they'll also significantly reduce the amount of scuffs and scratches it'll receive since the skid plates are the lowest impact point on the chassis
Both chassis versions
Out back, rear skid plate adds some much needed abrasion and wear protection. Whether you're running a molded chassis or an aluminum version, no one wants to replace a chassis because it wore out. It's much easier and less expensive to replace a skid / wear plate such as these. You'll also encounter less build-up of dirt and debris between the chassis and the lower rear bumper mount since the rear skid plate sits lower than the bumper mount.
Fits #LOS231023 molded chassis versions
Fits #LOS231056 aluminum chassis versions
Helps reduce / eliminate molded chassis breakage
Provides unmatched skid and impact protection