Black Rear Straight Ob Axles Ax10

Hot Racing optional aluminum straight rear axle with onboard power transmission to replace the Axial AX10 rear axle. The axle places the motor on the axle for a low CG.
- Compact gear case for low CG and more ground clearance
- Motor mounts to axle
- 11.4:1 internal gear reduction (in addition to the pinion/ 52T spur reduction)
- CNC machined 6061-T6 aluminum construction, anodized black
- CNC machined, nitride finished steel gears
- Clear gear box cover
- 5mm stainless steel axles
- Full ball bearing transmission
- Uses 48P pinion gear (not supplied)
- Aluminum servo, shock, and linkage mounts
- Supports 9T to 30T 48 pitch pinion gears
- One (1) aluminum rear straight on-board power axle with steel gear transmission
- Two (2) axle shafts
- Some parts from your stock AX10 set up (including outer axle bearings)
- Advanced hobby skills required
- Installation
- Removable thread adhesive on screws (not on clear gear cover as may crack the cover)
- Light grease lubricant of transmission
- Gearbox height: ~46mm
- Gearbox length: ~78.5mm
- Tube end to tube end: 182mm
- Axle pin hole to axle pin hole: ~184mm
- Gear box offset from middle of axle: ~24mm
- Input gear compound set: 52/14T
- Idle gear compound set: 40/12T
- Output gear: 48T
- Input shaft bearings: 2x 10x5x4mm (OD x ID x T)
- Idle shaft bearings: 10x5x4mm and 10x4x4mm (OD x ID x T)
- Output shaft bearings: 2x 15x10x4mm (OD x ID x T)
- A 12T, 48P pinion will produce a 49.5:1 final drive ratio
- Gear nitriding increased wear resistance, improved fatigue life, and enhanced corrosion resistance
- Replacement internal gear set is Hot Racing RSCP12SG
- Replacement axles are Hot Racing RSCP12SR or RSCP12SHD


description revised by: SN January 6, 2016